清洁与保养

1防止在搬运中出现的碰伤。

2清洁时，先用软布或干棉纱除灰尘，再用干布沾少许防锈机油擦抹，最后用干布抹干，保持干燥

3在不锈钢表面涂一层上光蜡，并用经常揩擦上光，保持常新，延长使用寿命

Maintenance of products :

1 Prevention from the scratches during the conveying process. 

2.Try not to moisten the metallic plating pieces. Sweep with soft cloth or dry cotton yarn, then wipe out with dry cloth stained with a little anti-rust oil. Finally dry up with dry cloth. Keep dry.

3 Coat one-layer light wax on the surface of the stainless steel. Keep it new, and prolong its service life.

皂液器安装步骤：

根据产品安装孔位，在墙面相应位置画出螺钉孔中心线后，用冲击钻分别钻φ6孔。

用铁锤小心将塑料胀塞打入墙面，不能突出墙面，可用小刀切除露墙外的部分。

用ST4.2螺丝将底座固定在墙面上。

将主体由上往下放在底座上。

将皂液器用M5的内六角紧顶螺钉固定在底座上。

按下顶部小盖，将洗手液注入。

用手推动下段按钮，洗手液即可流出。

Position the bores according to the product. Drill φ 6 bores respectively with impact driller,

Afterthe center line for bolt bore is drawn in the appropriate position on the wall.

Knock plastics bulge into the wall with hammer. Don't let it outstand the wall. Use a knife to

cut out the prominent part.

Use ST4.2 screws to fix base on the wall.

Place the main body on the base from top to bottom.

Fix the soap liquid appliance on the base with the M5 inner hexangular crest bolt.

Press the small cover on top to let in hand-washing liquid.

Push the downward button by hand, then hand-washing liquid runs off.